test
Installation instructions Pneumatic Powertool
On this page you'll find out how you need to use the Pneumatic Powertool 3352PTC-1 or 3352PTC-2.
The Pneumatic Powertool is the best way to install large amounts of Keenserts® in an effecient manner.
Through the use of this Pneumatic Powertool, you will save out a lot of time installing the Keenserts®
Step 1 | Step 2 | Step 3 | Step 4 | Step 5 |
Screw in the Keensert® by hand for about one or two turns. | Push the outer thread of the mandrel into the inner thread of the Keenserts®. The screw-in process will start automatically activated by the pushing force. | Do not press the trigger yet. The screw-in operation stops automatically once the insert reaches its final position (when the thicker part of the Kees touch the countersunk surface). | Then push the trigger for Kees to be pressed in. | Keep the trigger pressed, after the Kees are pressed in the mandrel, it will rotate counterclockwise until it gets out of the Keenserts®. Then release the trigger.
|
Note: if you need a certain tolerance, it will depend on the countersink
For more information on the Pneumatic Powertool, please contact us on info@anemo.eu