Is there a tool to pre-broach the key slots for the Keenserts?

For very hard materials with a hardness greater than 30 HRC or 300 Vickers it is necessary to pre-broach the slots for the kees.The first step is to mark the position of the kees on the parent material. To do this wind the keensert in until the kees touch the surface of the parent material. Mark the positions of the kees and unwind the keensert. Then line up the blades of the broaching tool with the marked positions and push it in with a hammer or under a press, remove the tool and install the keenserts. In some cases it may be necessary to run the tap back down the hole to clear out any burrs.

The broaching tool is available for external thread M5 and external imperial thread 1/4“ and up.

https://clinserts.com/what-broaching-tool-part-number-each-clinsert

Please verify with your customer if he requires 4 spare blades?
These can break if you manipulate the tool in a wrong way, or if you need to prepare too many holes.

What are the partnumbers for these tools?

>

Please note that each broaching tool is different.

By changing the blades, you won't be able to change to a different Keensert®

More information also availabe in the link below:

https://anemo.eu/how-can-we-mount-keensert-hards-material-use-broaching-tools